1997-2001 Honda CR250

After five years of nights and weekends, I'm finally done rebuilding my 1997 CR250, and just in time for quarantine season! All that's left...

After five years of nights and weekends, I'm finally done rebuilding my CR250—just in time for quarantine season!All that's left to do is give...

How To Service The Water Pump On Your 1997-2001 Honda CR250Your water pump is located at the front of your crankcase on the right...

What Are The Signs Of A Bad Water Pump? Your water pump is located at the front of your crankcase on the right side. Right next to the oil level plug is a tiny opening. The other side of this opening sits between the impeller shaft oil and coolant seals. If you can see oil, coolant, or both coming out of that opening, your water pump is no longer sealed and needs to be repaired. You can change the gasket on your water pump without removing the right crankcase cover. But if you need to change the seals, bearing, or impeller, your right crankcase cover must be removed.

The radiator is the most fragile component of your dirt bike's engine, but it's mounted right behind the fender, so you should inspect it...

The radiator is the most fragile component of your dirt bike's engine, but it's mounted right behind the fender, so you should inspect it regularly. On 1997 - 1999 models, the radiator is one piece, and on 2000 - 2001 models, the radiator is a two-piece design with hoses connecting each side. This service applies to both types of radiators, as well as pretty much every radiator.

Cooling System Specifications For Your 1997-2001 Honda CR250 Dirt Bike If you need parts and tools, make sure to buy them here! → https://amzn.to/4h4lDKqCooling System...

If the clutch on your Honda CR250 is binding when you torque the center bolt, pull the outer and check how far the kickstarter gear is sticking out from the back of the basket. I want to give a huge shoutout to Brian from Georgia for figuring out a problem I didn’t even know existed! Brian was experiencing this binding issue, so I asked him to send me a message on Facebook so we could troubleshoot with pictures and video, and we found the thrust washer was worn out, problem solved, right?

If the clutch on your Honda CR250 is binding when you torque the center bolt, pull the outer and check how far the kickstarter...

How To Remove And Install The Stator 1997 - 2001 Honda CR250 Do not remove your stator for testing!All testing for the exciter coil and...